lion News

Building with flexible blocks

On an apparently normal cube a pattern of hollows and bulges appears when the cube is compressed. Physicists from Leiden University and FOM Institute AMOLF together with colleagues from Tel Aviv University have developed a method to design such three-dimensional structures and to construct these using simple building blocks. This paves the way for the use of 'machine materials' in, for example, prostheses and wearable technology. The researchers will publish their findings on 28 July in Nature.

Normally, atoms and molecules determine the properties of the materials they form. However that is different for 'metamaterials' designed by humans. "In the case of metamaterials, the spatial structure determines the material's behavior," explains group leader Martin van Hecke. "For example, a pattern of holes in a sheet of material gives rise to a mechanical response that is completely different than in the same material without holes. We also wanted to investigate this phenomenon for a three-dimensional pattern of holes."

3D puzzle
Van Hecke and his colleagues designed a cube-shaped, flexible building block with a hole in it. If pressure is applied to such a block then some of the sides cave in, whereas others bulge out. By stacking several of these building blocks researchers could make three-dimensional structures. Van Hecke: "The orientation of the blocks in the metamaterial is important. Under pressure, all of the hollow and bulging sides must fit exactly together. Most of the stacks are 'frustrated': somewhere within two hollows or bulges meet. However a large number of fitting solutions for this three-dimensional puzzle were found."

Patterns
Van Hecke's colleagues at Tel Aviv University calculated the number of possible, non-frustrated stacks for different cubes of building blocks. "For one cube of 14x14x14 building blocks that is a number with no less than 65 figures," says Van Hecke. "For each possible stack the deformation within the cube results in a specific pattern on the sides of the cube. By smartly combining the building blocks we can program the material such that every desired pattern appears on the sides of a compressed cube. Surprisingly such a cube can also be used to analyse patterns. If we press it against a pattern of hollows and bulges then we measure a force that is dependent on the pattern."

Machine materials
Although Van Hecke's research is fundamental in nature there are applications on the horizon. "This type of programmable 'machine materials' could be ideal for prostheses or wearable technology in which a close fit with the body is important," says Van Hecke. "If we can make the building blocks more complex or produce these from other materials then the possibilities really are endless."



Article
Corentin Coulais, Eial Teomy, Koen de Reus, Yair Shokef and Martin van Hecke, 'Combinatorial Design of Textured Mechanical Metamaterials', Nature, 535, 529-532 (2016), DOI:10.1038/nature18960

Image Caption
To demonstrate that any pattern can be produced on a cube's surface, the researchers developed a cube of 10x10x10 blocks on which a smiley appears when the cube is compressed. Credits: Corentin Coulais



Contact
Erik Arends
Physics Outreach Officer
arends [at] physics.leidenuniv.nl
+31 (0)71 527 5471
Twitter: @LeidenPhysics

Publ. 28-07-2016 09:00
More News